1975 D S E R I E S
TRANSMISSION
CONTROL LINKAGE
\
FIG. 12.
PRESSURE TESTING
Use a
0
to
1000
Ib.
gauge for all pressure testing.
Block the rear axle
so
the wheels are off the floor.
All pressure testing should be
performed at or near
full throttle with the wheels turning. Turn the wheels
by moving the speed
control lever into forward
or
reverse.
CHARGE PRESSURE TEST
Charge pressure
i s a n indication of transmission
condition. Connect the pressure gauge as shown
in
Fig.
13
to the
1/4"
pipe plug located between the imple-
ment hose ports. The
alternate port (straight thread)
just above this port may be
used
if
it
i s
more con-
venient.
With the engine running at
3/4
throttle the charge
pressure should be
70
to
150 PSI.
The pressure must
never drop below
50 PSI
under any condition. Always
take pressure tests
when the transmission
oil i s cold
24
FIG. 13.
Charge Pressure Test
Separated System