Changing The Control Logic - Mitsubishi Electric FR-F740 EC Instruction Manual

Wiring
3.4.4

Changing the control logic

The input signals are set to source logic (SOURCE) when shipped from the factory.
To change the control logic, the jumper connector on the control circuit terminal block must be
moved to the other position.
(The output signals may be used in either the sink or source logic independent of the jumper con-
nector position.)
Fig. 3-18: Changing the control logic
NOTE Turn off the inverter power before switching a jumper connector.
FR-F700 EC
Control circuit specifications
I001028E
3 - 27