Pg Speed Control Board Terminals And Specifications - YASKAWA Varispeed CIMR-G7A Instruction Manual

Preventing C and D Option Board Connectors from Rising
After installing an option board into slot C or D, insert an option clip to prevent the side with the connector
from rising. The option clip can be easily removed by holding onto the protruding portion of the clip and pull-
ing it out.
Remove the option clip before installing an option board into slot C or D. The option board can not be
installed completely and may not function properly if it is installed with the option clip attached.
A option board mounting spacer
(Provided with A Option Board.)
Option Clip
(To prevent raising of
C and D option boards)
3CN
D option board connector

PG Speed Control Board Terminals and Specifications

The terminal specifications for the PG Speed Control Boards are given in the following tables.
PG-A2
The terminal specifications for the PG-A2 are given in the following table.
Terminal
TA1
TA2
-32
2
A option board mounting spacer hole
4CN
A option board connector
2CN
C option board connector
A option board
Fig 2.21 Mounting Option Boards
Table 2.15 PG-A2 Terminal Specifications
No. Contents
1
Power supply for pulse generator
2
3
+12 V/open collector switching ter-
minal
4
5
Pulse input terminal
6
7
Pulse motor output terminal
8
(E) Shield connection terminal
C option board mounting spacer
C option board
D option board
D option board mounting spacer
A option board mounting spacer
Specifications
12 VDC (±5%), 200 mA max.
0 VDC (GND for power supply)
Terminal for switching between12 V voltage input
and open collector input. For open collector input,
short across 3 and 4.
H: +4 to 12 V; L: +1 V max. (Maximum response fre-
quency: 30 kHz)
Pulse input common
12 VDC (±10%), 20 mA max.
Pulse monitor output common
-