Setting The System 1; Setting The Number Of Lines To Be Ignored - Kyocera Fax System L Service Manual

3JF
Maintenance
item No.
U650

Setting the system 1

Description
Makes settings for fax reception regarding the sizes of the fax paper and received images and automatic
printing of the protocol list.
Start
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item to be set using the up/down cursor keys.
3. Press the start key.
The screen for the selected item appears.
Display
CUT LINE (100%)
CUT LINE (AUTO)
CUT LINE (A4)
RX WIDTH 11"
PROTOCOL PRT
Setting the number of lines to be ignored when receiving a fax at 100% magnification
Sets the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when recording the data at 100% magnification. If the number of excess lines is below the setting, those lines
are ignored. If over the setting, they are recorded on the next page.
1. Change the setting using the numeric keys.
Description
Number of lines
to be ignored
when receiving
at 100%
Increase the setting if a blank second page is received, and decrease it if the received image does not
include the entire transmitted data.
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting the number of lines to be ignored when receiving a fax in the auto reduction mode
Sets the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when the data is recorded in the auto reduction mode. If the number of excess lines is below the setting, those
lines are ignored. If over the setting, the entire data on a page is further reduced so that it can be recorded on
the same page.
1. Change the setting using the numeric keys.
Description
Number of lines
to be ignored
when receiving in
the auto reduction mode
Increase the setting if a page received in the reduction mode is over-reduced and too much trailing edge
margin is left. Decrease it if the received image does not include all transmitted data.
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
1-3-26
Description
Sets the number of lines to be ignored when
receiving a fax at 100% magnification.
Sets the number of lines to be ignored when
receiving a fax in the auto reduction mode.
Sets the number of lines to be ignored when
receiving a fax (A4R, letter) in the auto reduction
mode.
Sets the recording width for inch specifications.
Sets the automatic printing of the protocol list.
Setting range Initial setting Change in value per step
0 to 22 3
Setting range Initial setting Change in value per step
0 to 22 3
Description
16 lines
16 lines