Setting The Recording Width For Inch Specifications; Setting The Automatic Printing Of The Protocol List - Kyocera Fax System L Service Manual

Maintenance
item No.
U650 Setting the number of lines to be ignored when receiving a fax (A4R, letter) in the auto reduction mode
(cont.) Sets the maximum number of lines to be ignored if the received data volume exceeds the recording capacity
when the data is recorded in the auto reduction mode onto A4R or letter-size paper under the conditions below.
If the number of excess lines is below the setting, those lines are ignored. If over the setting, the entire data on
a page is further reduced so that it can be recorded on the same page.
• With A4R present and folio absent in the drawers
• With letter-size paper present and legal-size paper absent in the drawers
1. Change the setting using the numeric keys.
Description
Number of lines
to be ignored
when receiving a
fax (A4R, letter) in
the auto reduction mode
Increase the setting if a page received in the reduction mode is over-reduced and too much trailing edge
margin is left. Decrease it if the received image does not include all transmitted data.
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.

Setting the recording width for inch specifications

Sets the maximum recording width and processing method when 11" width fax paper is loaded on an inch-
specification machine.
1. Enter 1 or 2 using the numeric keys to change the setting.
Display
1: 11 × 17
2: B4
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.

Setting the automatic printing of the protocol list

Sets if the protocol list is automatically printed out.
1. Change the setting using the numeric keys.
Display
1: OFF
2: ERROR
3: ON
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item No. is
displayed.
Setting range Initial setting Change in value per step
0 to 22
Description
Communicates to the destination unit 11" width as A3 width and
records at 100% magnifications.
Communicates to the destination unit 11" width as B4 width.
The protocol list is not printed out automatically.
The protocol list is automatically printed out after communication
only if a communication error occurs.
The protocol list is automatically printed out after communication.
Description
3 16 lines
Description
3JF
1-3-27