Error And Status Messages On The Screen; Cover Open - Ricoh SP 3510SF Quick Manual

Troubleshooting

Error and Status Messages on the Screen

"X" indicates the parts of the messages that appear differently depending on a spe-
cific situation, such as paper sizes, paper types, or tray names.
Message
(alphabetical order)
ADF Orig. Misfeed
Open ADF Cover
and remove paper.
Check Paper Size
Check Paper Type

Cover open

Dest. is not
Programmed
Failed to Access
File Press Clear key
Failed to Create File
Press Clear key
26
Causes
An original has been
jammed inside the
ARDF or ADF.
The paper size set for
the document differs
from the size of the
paper in the tray.
The paper type set for
the document differs
from the type of the
paper in the tray.
A cover is open.
No Quick Dial entry
is associated with the
One Touch button you
pressed.
The Scan to USB
function failed
because the machine
could not access
the USB flash disk
properly.
The Scan to USB
function failed
because there was
not enough memory
on the USB flash disk.
Solutions
• Remove jammed originals,
and then place them again.
See "Removing from the
ARDF or ADF" on page 40.
• Check the originals are suit-
able for scanning. See "Plac-
ing Originals", User Guide.
Press [FormFeed] to begin
printing, or press [JobReset] to
cancel the job.
Press [FormFeed] to begin
printing, or press [JobReset] to
cancel the job.
Close the cover completely.
• Press a different One Touch
button.
• Assign a registered destination
to the One Touch button. See
"Registering Scan Destina-
tions", User Guide.
Use a USB flash disk that is not
password- or write-protected.
Use a USB flash disk with
enough memory.