Universal Battery Charger (Ubc) Adapter; Inserting And Removing A Battery; Setup - Motorola MC909X Integrator Manual

2 - 26 MC909X Integrator Guide

Universal Battery Charger (UBC) Adapter

CAUTION Ensure that you follow the guidelines for battery safety described in
10-1.
This section describes how to use the UBC adapter to charge a spare battery.
The UBC can be used with a power supply as a standalone spare battery charger or it can be used with the four
station UBC2000 to provide charging to simultaneously charge up to four spare batteries. For additional
information about the UBC2000, see the UBC 2000 Universal Battery Charger Product Guide (p/n 70-33188-xx)
.
Battery Release
Battery Well
UBC Adapter
Figure 2-27

Inserting and Removing a Battery

Insert the battery into the battery well with the charging contacts facing down (over charging pins) and gently press
down on the battery to ensure proper contact.
To remove the battery, press the battery release and lift battery out of the well.

Setup

CAUTION
Battery
Use only a Symbol approved power supply output rated 15 VDC and minimum 1.5 A. Use of an alternative
power supply will void the product warranty and may cause product damage. Refer to the MC909X User
Guide for the power supply regulatory compliance statement.
Battery Safety Guidelines on page
UBC Adapter
POWER
READY or STANDBY or FAULT
(Green) (Flashing Yellow) (Solid Yellow)
CHARGING
(Solid Yellow)