Setup - Motorola MC909X Integrator Manual

2 - 10 MC909X Integrator Guide
Communication LED
Table 2-2
Status
Off
Solid Red
Flashing Green
Slow Flashing Red
Fast Flashing Red
Solid Green
All LEDs Flashing Red

Setup

CAUTION
NOTE The Four Slot Ethernet cradle must be connected to a power source and to an Ethernet Hub (when
applicable).
Four Slot Ethernet Cradle Power Connection
Figure 2-9
Mobile computer is not in cradle; mobile computer not placed correctly; cradle is
not powered.
Mobile computer is present, but communication has not started.
Mobile computer is in the cradle, and communicating with the host computer.
Error, communication did not start.
Warning: Terminal inactivity time-out. The terminal did not finish data
synchronization or had an open connection for more than 15 minutes. This time is
programmable in the cradle flash parameters.
Terminal is present in the slot and communication is complete.
Failed automatic cradle configuration via local DHCP Service.
Use only a Symbol approved power supply output rated 12 VDC and minimum 9 A. Use of an alternative
power supply will void the product warranty and may cause product damage. Refer to the MC909X User
Guide for the power supply regulatory compliance statement.
AC Line Cord
Indication
Ethernet
Communication Port
Power Port
DC Cable
To Ethernet
Hub
Power Supply