Removing The Oil Filter; Installing The Oil Filter - KTM 690 Enduro R EU 2013 Repair Manual

20 LUBRICATION SYSTEM
20.6

Removing the oil filter

Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
20.7

Installing the oil filter

–
Thoroughly clean the oil drain plug with a magnet.
–
Mount the oil drain plug with the magnet and seal ring and tighten it.
Guideline
Oil drain plug with magnet
100201-01
Preparatory work
–
Place a suitable container under the engine.
Main work
–
Remove screws
–
Pull oil filter
Circlip pliers reverse (51012011000) (
100202-10
–
Remove screws
–
Pull oil filter
Circlip pliers reverse (51012011000) (
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
C00181-10
–
Insert oil filters
–
Oil the O-rings of the oil filter covers. Mount oil filter covers
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
100204-10
. Remove the oil filter cover
1
out of the oil filter housing.
3
. Take off the oil filter cover
4
out of the oil filter housing.
6
and .
1 2
M12x1.5 20 Nm
(14.8 lbf ft)
with the O-ring.
2
p. 215)
with the O-ring.
5
p. 215)
and .
3 4
M5 6 Nm (4.4 lbf ft)
172