Adjusting Valve Clearance - KTM 690 Enduro R EU 2013 Repair Manual

17 ENGINE

17.5.22 Adjusting valve clearance

–
Remove the special tool.
Engine blocking screw (77329010000) (
–
Mount and tighten screw
Guideline
Screw plug, crankshaft clamp
306140-10
–
Remove screws
Info
Make sure that the crankshaft is at top dead center.
300156-10
–
Screw suitable screws
shafts.
–
Take off the rocker arm.
300157-10
–
Remove shims
–
Correct the shims as indicated by the results of the valve clearance check.
–
Insert suitable shims.
–
Position the rocker arms and push in the rocker arm shafts.
Info
Make sure that the tapped hole of the rocker arm shaft is positioned facing
outwards.
The small drill hole and the flat surface must point upwards.
300158-10
–
Install and tighten the screws
Guideline
Screw, rocker arm shaft
–
Check the valve clearance. (
300156-11
with the washer.
3
.
1
into the rocker arm shafts
2
and set them down according to the installation position.
4
of the rocker arm shafts.
5
p. 158)
p. 222)
M8 20 Nm
(14.8 lbf ft)
. Pull out the rocker arm
3
M6 12 Nm (8.9 lbf ft)
159