Table of Contents
Advertisement
Label
Connection description
PC Card
Insert approved PCMCIA card for network or modem connectivity. Card validation occurs after
powerup, and can be verified on the System Information screen (see
Information
read the PCMCIA card.
Note
SCSI
Connect an external RAID device to this SCSI connector:
1. Connect an external SCSI device to the 68-pin SCSI control port on the rear panel. Set the
SCSI ID in the range of 4 to 6. The SCSI ID must not conflict with the ID of internal SCSI
devices.
2. Apply power to the external device prior to turning the HRDV on. This HRDV queries the
device during start up to ensure it is functioning properly.
Note
Power
The power for the HRDV16/8 unit is 110 VAC/60 Hz (NTSC) and 220 VAC/50 Hz (PAL).
Rev 1.00
Table 3-1
Rear Panel Connections (Cont'd)
on page 183). You must enable remote access for the system to recognize and
A list of supported devices is posted on the Honeywell Video Systems web site.
A list of supported devices is posted on the Honeywell Video Systems web site.
See
Appendix D
for typical network installations.
17
HRDV Reference Guide
Viewing System
Document 900.0261
04/05
Advertisement
Table of Contents
