Table of Contents
Advertisement
Performing an Initial System Check
Turning On the HRDV the First Time
Rebooting (Restarting) the HRDV
Attaching a Monitor
Setting the HRDV to Factory Defaults
Rev 1.00
1.
Unpack the HRDV and place it on a flat surface.
2.
Attach the AC power cord to the HRDV rear panel (see
end into an 110 VAC receptacle.
Observe the LCD display on the HRDV front panel. The message Power up displays
3.
alternately between the top and bottom of the LCD screen for approximately 60
seconds.
4.
The time and date displays indicating the HRDV is ready for operation. You can now
attach a monitor.
There is no on/off switch on the HRDV. To restart it:
1.
Disconnect the power cable from either the HRDV or from the wall socket.
2.
Wait 15 seconds, then re-connect the power cable to apply power to the HRDV.
This wait allows any stored capacitance to discharge clearing memory for proper
operation.
1.
Plug your monitor into an AC receptacle.
2.
Connect a BNC cable to the Video In jack on the monitor. Connect the other end of
the BNC cable to the Mon 1 jack on the HRDV rear panel (see
3.
Turn on your monitor, then press the MENU button on the HRDV. The monitor
displays a Select a user login screen.
You are now ready to set the HRDV to factory defaults.
1.
Log in to the HRDV (see
2.
From the Main Menu screen, select System Setup.
3.
Select Default Settings.
Entering Program
Mode, page 19).
13
HRDV Reference Guide
Figure
3-1) and plug the other
Figure
3-1).
Document 900.0261
04/05
Advertisement
Table of Contents
