Table of Contents
Advertisement
Field (Cont'd)
Gateway
Method
Baud Rate
Advanced Setup
RS-485 Setup
Baud Rate
HRDV Address
Dome Address
Rev 1.00
Description
See
Subnet Mask
above.
Options are:
IEEE 802.3 (Ethernet). Connection via Ethernet LAN
Serial (PC Card). Connection by dial-up modem
Serial (EIA-232). Connection by DB-25 Comm port on rear panel
The data transmission speed. For dial-up modem or serial port connection,
specify the baud rate. If you are using a noisy phone line, use a lower baud rate.
Otherwise, use the highest rate supported.
Select Advanced Setup to enable alarm and e-mail notification over TCP/IP.
See
page 142
for more information.
Allows you to control the Pelco®, Kalatel, Vortex and VCL PTZ cameras. For more
information, see
Chapter 21, Pan, Tilt, Zoom
The data transmission speed.
Sets the HRDV Address (1 to 254). This address is typically predetermined by a
system plan. Options are:
HRDV is Master: The HRDV unit is controlling the dome camera.
HRDV is Slave: An external controller is controlling the dome camera.
Address of the dome camera. Options are:
Camera 1 to 16
Dome Address: 1 to 254
Protocol: Kalatel, VCL, Pelco D or Vortex
137
HRDV Reference Guide
(PTZ).
Document 900.0261
04/05
Advertisement
Table of Contents
