Installing Usb Firmware Update Driver (For The Usb Port Model Only) - Panasonic UF-8300 Service Manual

2.3

Installing USB Firmware Update Driver (For the USB Port Model Only)

After installation of the Local Firmware Update Tool, if you need to install the USB Firmware
1
Update Driver, please first set the unit to "Update from USB/* IN PROGRESS *" in the Service
Mode, and then connect the USB Cable. The required Driver will then be installed automatically.
Note:
For instructions of how to enter the Service Mode, refer to your device's Service Manual.
Searching...
2
Installing driver...
When the install screen disappears, the
3
installation of the Firmware Update (USB)
Driver is completed.
Note:
1. The installation screens will vary depending on the Operating System.
2. The "Digital Signature Not Found" or "Software Installation" window will be displayed during the
installation and indicate "Unknown software package" or "not passed Windows Logo testing", please click
[YES] or [Continue Anyway] button to continue the installation.
3. If you are asked for the inf file location, please specify the following folder.
C:\Panasonic\Panasonic-FUP\UsbDrv1
4. If you are asked for the inf file selection, please chose the larger version of the file.
5. After the USB Firmware Update Driver is installed, and if you are not updating the machine's firmware at this
time, turn the Power Switch OFF and ON again to return your machine to the Standby mode.
Local Firmware Update Tool (Parallel/USB Port)
Page 5