Print Process - Panasonic UF-8300 Service Manual

6.3.2.

Print Process

Fusing : Heat Roller
(Paper Path) (Paper Path)
Fusing : Pressure Roller
6.3.2.1. Charge
The Charge Corona applies a high, uniform positive charge to the surface of the Organic Photo Conductor
(OPC) Drum. The charge level is approximately 900 VDC and remains because the OPC Drum has a high
electrical resistance when concealed in darkness.
6.3.2.2. Exposure
The laser beam passes through the Collimator Lens, is reflected by the Polygon Mirror, and is focused onto
the drum after passing through an image-forming (
beam strikes the drum, the positive charge dissipates. A latent electrical image of two different voltages
potentials, which corresponds to the original page, is formed on the OPC Drum.
6.3.2.3. Development / Cleaning
Development:
Non-magnetic Toner is supplied to the Conductive Roller by the Toner Supply Roller. The Toner on the
Conductive Roller is positively charged by friction with the Toner Supply Roller, and the Doctor Blade
ensures a thin layer on the surface of the Conductive Roller. Wherever the Conductive Roller touches the
drum, the positively charged toner is attracted to the latent image on the drum, and the latent image is
converted to a visible toner image. A bias voltage of approx. 350 VDC is applied to the Conductive Roller to
achieve maximum print quality.
Charge : Charge Corona
Doctor Blade
OPC Drum
Development / Cleaning : Conductive Roller
Transfer : Bias Transfer Roller (BTR)
Exposure : LSU
Toner Supply Roller Toner Supply Roller
Pick Up Roller
) Lens and a Reflection Mirror. Wherever the laser
194
UF-8300/8200
UF-7300/7200
Development
(Toner Area)
Feed Roller