Panasonic UF-8300 Service Manual page 191

5.2.8. Service Mode 9 (System Maintenance)
5.2.8.1. Overview
This Service Mode is used to maintain the machine. Use the following procedure for System Maintenance.
Step
1 Stand-by
2 Press the "Function" and the "7" keys.
3 Press the "Monitor" key four times, then press the "*" key.
4 Press the "9" key.
5 Press the "Set" and the "Start" keys.
After the backup is completed, repeat step 4 through 5 to request an
6
operation.
7 Press the "Stop" key twice to return to stand-by.
Note:
If there is NO File in the machine, this operation will not function.
Press the "Stop" key twice to exit the service mode.
No. Maintenance Mode
1 Firmware update
3 PARAMETER RESTOR Restores the parameters from the Backup Card into the machine.
4 PARAMETER BACK UP Creates a Backup Card of the machine's parameters. (A 1 MB, or higher
8 Send RCV'D File
Service Mode 9
Operation or Unit Condition
System Maintenance Table
PC --> Host
Updates the firmware in the machine with the Master Firmware from the
PC. After the firmware is updated, the machine reboots automatically
and returns to standby.
Flash Memory Card is required)
Transfers documents from memory to another fax machine during a fatal
printer error.
Description
191
UF-8300/8200
UF-7300/7200
LCD Display
MMM-dd-yyyy 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
SYSTEM MAINT. (1-8)
1:FIRMWARE UPDATE
FIRMWARE BACKUP
* IN PROGRESS *
SERVICE MODE
ENTER NO. OR
MMM-dd-yyyy 15:00
00%