Panasonic UF-8300 Service Manual page 131

LCD 1: [TONER IS RUNNING LOW: U13]
Low Toner sensor detects Low Toner or the machine has printed
Preparing a new cartridge for replacement is recommended.
LCD 2: [WARNING TONER LOW LESS THAN 50 PAGES]
450 pages have been printed since the LCD 1 appeared.
Replacement with the new cartridge is recommended.
LCD 3: [OUT OF TONER: E13]
50 pages have been printed after LCD 2 appeared.
Replace with the new cartridge.
When replacing with a New Cartridge, refer to the Operating Instructions (For Facsimile).
4.7.2. Jam Error Codes (J Code)
Code
J01 The Registration Sensor did not detect paper within a predetermined time after the Paper
Feed Roller started rotating. (1st Feeder Unit)
J02 The Registration Sensor does not detect paper within a predetermined time after the
Paper Feed Roller started rotating. (2nd Feeder Unit)
J43 Paper Jam in the Registration Sensor or Paper Path Sensor.
J44 Paper Jam in the
J71 Original was longer than
(Information Code
J72 Read Point Sensor does not go ON within several seconds after the original starts
feeding.
(Information Code 030 is printed on the Transaction Journal instead.)
J74 The Exit Sensor does not go ON within a predetermined time after the Sensor is
activated.
J75 The Exit Sensor does not go OFF within a predetermined time after the Sensor is
activated.
J92 The Original was pulled out when feeding an original.
J93 The Original remained in the ADF.
J94 The ADF does not go off after the predetermined time.
Unexpected Jam timing (i.e. Original is too short, etc.)
A
Section
A ADF
B Paper Transport / Exit Area
C Paper Entry Area
Jam Error Codes (J Codes) Table
Paper Exit Sensor.
39.3 in (1m).
031 is printed on the Transaction Journal instead.)
B
C
Jam Location
Contents
131
11,000 pages.
UF-8300/8200
UF-7300/7200
Section
C
B, C
A