Job Offset Home Position Error - Xerox Phaser 7400 Service Manual

Job Offset Home Position Error

Applicable Status Code:
Code U60:
Job Offset Home Position Sensor does not detect home position for the
Job Offset Assembly.
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Offset Home Position Sensor, PL11.1.32
Rear Sensor Board, PL11.1.33
Job Offset Assembly, PL13.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Home Position Sensor Actuator
Home Position Sensor
SNS Harness
Is there any damage or misalignment?
2 Test the Job Offset Home Position Sensor.
Run the Service Diagnostics Offset Home
Position test.
Does the sensor function correctly?
3 Replace the Job Offset Home Position
Sensor.
Does the error persist?
4 Check the SNS connection.
Is SNS connected to the Rear Sensor
Board?
5 Check for +5V to the sensor.
Disconnect P/J150.
Is there +5 V at J150-1?
3-146
Wiring and Plug/Jack References
Print Engine Map 7 (page 10-10)
Print Engine Map 11 (page 10-14)
Print Engine Rear Sensor Board (page 10-29)
Yes
Replace any
damaged parts.
Replace the Engine
Control Board
(page 8-112).
Go to Step 4.
Go to Step 5.
Go to Step 6.
Phaser 7400 Color Printer Service Manual
No
Go to Step 2.
Go to Step 3.
Complete.
Reconnect the
harness.
Replace the Rear
Sensor Board
(page 8-151).