Finisher Inverter Firmware Error - Xerox Phaser 7400 Service Manual

Finisher Inverter Firmware Error

Applicable Status Code:
Code 227: A software error with the Inverter's Flash Memory.
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Inverter Control Board
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Inverter Interface Cable
Inverter connections
Is there any damage?
2 Check the Inverter connection.
Is the Inverter interface cable securely
connected at both ends?
3 Check the version of Inverter firmware.
Is the latest version installed?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 3 (page 10-6)
Print Engine Motor Driver Board (6/6) (page 10-36)
Options Map 3 Inverter Controller Board
Yes
Replace any
damaged parts.
Go to Step 3.
Replace the Inverter
Control Board.
No
Go to Step 2.
Connect the
Inverter to the
Finisher.
Reload the Inverter
firmware.
3-153