Jam In Fuser - Xerox Phaser 7400 Service Manual

Jam in Fuser

Media reached the Media Slack Sensor, but did not clear the Fuser Exit Sensor on
time. This error represents a jam inside the Fuser.
Applicable Status Code:
Code TC2: Jam in Fuser
Initial Actions:
Remove the Fuser and check for any obstructions, media, damage, or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Warning
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 2 of the following troubleshooting procedure.
Caution
Allow adequate time for the Fuser to cool before servicing the printer.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL1.1.21
Fuser Exit Sensor, PL11.1.13
Rear Sensor Board, PL11.1.33
Fuser Motor, PL2.1.9
Motor Driver Board, PL2.1.10
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Fuser
Fuser Exit Actuator and Sensor
Fuser Motor
Is there any damage?
2
Remove the Fuser and check for broken or
bent connector pins or damaged gears.
3 Reinstall the Fuser.
Does the error persist?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 2 (page 10-5)
Print Engine Map 5 (page 10-8)
Print Engine Map 11 (page 10-14)
Print Engine Rear Sensor Board (page 10-29)
Print Engine Motor Driver Board (2/6) (page 10-32)
Yes
Replace any
damaged parts.
Repair or replace
damaged parts.
Go to Step 4.
No
Go to Step 2.
Go to Step 3.
Complete
3-31