Tray 1 (Mpt) No Paper Sensor - Xerox Phaser 7400 Service Manual

Tray 1 (MPT) No Paper Sensor

Note
A non-captive spring is installed in the Rear Chute to tension the Retard Roller.
1. Remove Tray 1 (MPT)
2.
Open the tray assembly and depress the lift plate to remove 1 (black, 10 mm)
screw at the center.
3. Remove 2 (black, plastic 10 mm) screws that secure the Rear Chute to the
Tray 1 (MPT).
4.
Separate the Rear Chute from the assembly.
5. Release the hooks that secure the sensor to the Rear Chute.
6. Disconnect the sensor connector (P/J460).
Replacement Note
Insert the spring underneath the Retard Roller before installing the Rear
Chute. Make sure the lift levers are above the Lift Plate.
Service Parts Disassembly
Sensor Cover
Sensor Hooks
Tray 1 (MPT) Rear Chute
Retard Roller Spring Location
s7400-426
8-33