Fuser 110V/220V Mismatch Failure - Xerox Phaser 7400 Service Manual

Fuser 110v/220v Mismatch Failure

An error was detected in the Fuser.
Applicable Status Code:
Code U33:
Fuser Mismatch Failure
Initial Actions:
Cycle the printer's power.
If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser PL1.1.21
Engine Control Board, PL1.1.4
Troubleshooting Procedure Table
Step Actions and Questions
1 Ensure the proper Fuser (110v vs. 220v) is
installed in the printer.
Is the correct Fuser installed?
Error Messages and Codes
Wiring and Plug/Jack References
Yes
Replace the Engine
Control Board
(page 8-112).
No
Replace the Fuser.
3-113