Table of Contents
Advertisement
Figure Q7: Teak Swim Platform
Before teak can be given any coating, it must be
completely cleaned. Follow the manufacturer's direc-
tions with regard to cleaning. Once cleaning has been
accomplished there are finishes that may be applied
such as teak oil (traditional), sealers, or varnishing.
Again, Four Winns recommends following the table
manufacturer recommendations. Additional note:
There are numerous teak products on the market that
may be tried that will give you the look you desire.
Your Four Winns dealer can also provide you with
some helpful suggestions.
NOTICE
DO NOT use abrasive cleaners or sol vents on
cockpit table. DO NOT use Soft Scrub™ soap
or similar cleaning prod ucts; they will scratch
the surface and remove the shine.
NOTICE
DO NOT use tables as a cutting board. The
knife will leave gouges/marks in the surface of
the table. Use an actual cutting board in order
to protect the tables.
Q - 5 ACRYLIC PLASTIC - (Plexiglass)
Acrylic plastic is utilized in most walk-thru doors, wind-
screens, transom doors, portlight windows, electrical
panel doors and certain glove boxes.
To clean acrylic plastic:
1. Rinse with plenty of water to wash off as much dirt
as possible.
2. Using your bare hand, along with plenty of water,
feel and remove any dried-on dirt or mud.
Woodwork and Composites - Section Q
3. Wash using a soft, grit-free cloth or sponge and
mild, nonabrasive soap or detergent.
4. Rinse thoroughly with water.
5. Blot dry using a clean, damp chamois.
NOTICE
Never use a dry cloth, duster, glass cleaning
solutions or citrus cleaner on acrylic plastic.
NOTICE
Do not use solvents such as acetone, silicone
spray, benzine, carbon tetrachloride, fire ex-
tinguisher fluid, dry cleaning fluid, lacquer
thinner or ammonia. These solutions damage
the acrylic surface.
You can use fine automotive acrylic rubbing and
polishing compounds to remove fine scratches on
acrylic. Always read the label before using any prod-
uct.
Owner's Manual Page 126
Advertisement
Table of Contents
