06/08/05 21:50:51 32SMG610_057
Installing a Child Restraint System
3.
To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops.
54
Driver and Passenger Safety
4.
Push down the tab. Route the
shoulder part of the belt into the
slit at the side of the restraint,
then let the belt feed back into the
retractor.
5.
After the belt has retracted, tug
on it. If the belt is locked, you
will not be able to pull it out. If
you can pull the belt out, it is not
locked, and you will need to
repeat these steps.
6.
After confirming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child restraint system will not
be secure.