Honda Civic Owner's Manual page 100

06/08/05 21:56:45 32SMG610_100
Rear Seat Belt Use Monitor
When you turn the ignition switch to
the ON (II) position, the upper
segment of the multi-information
display shows the rear seat belt use.
This monitor goes off after about 30
seconds. It will also go off when you
change the display by pressing the
system message button on the
steering wheel.
Seat belts in right and centre
positions are used.
The seat belt system detects any
seat belt use of all three rear seat
seating positions according to each
seat belt buckle latch function. The
system shows you how many rear
seat belts are being used and
reminds you and your passengers to
fasten their seat belts. According to
the rear seat belt use (1 through 3),
you will see the indicator(s)
highlighted on the right side of the
upper segment.
Multi-Information Display
While driving, you can also confirm
the rear seat belt use. Press and
release the INFO button (
repeatedly to change the display.
If the system cannot detect the seat
belt use, you will see three dashes.
Turn the ignition switch to the
LOCK (0) position to reset the
system. If this happens, the SRS
indicator also comes on. Have your
vehicle checked by your dealer (see
page 30 ).
Instruments and Controls
)
97