Getting St 3000 Transmitter On-Line Quickly; Table 4 Start-Up Tasks Reference - Honeywell ST 3000 User Manual

2.2

Getting ST 3000 Transmitter On-Line Quickly

Quick start-up tasks
16 ST 3000 Release 300 and SFC Model STS103 User's Manual
Table 4 lists common start-up tasks for an ST 3000 transmitter using an
SFC and gives an appropriate section in this manual to reference for
more information about how to do the task. The start-up tasks are listed
in the order they are commonly completed.
Table 4 Start-up Tasks Reference
Task Description
Put analog loop into manual
1
mode.
2 Connect SFC to transmitter and
establish communications.
3 Check or set tag ID.
Identify transmitter's mode of
4
operation.
Change mode of operation, if
5
required.
Check/set output form
6
(Linear/Square Root).
7 Check/set damping time.
8 Check/set Lower Range Value
and Upper Range Value.
9 Run optional output check for
analog loop.
10 Check zero input and set, if
required.
11 Check transmitter status.
Setup local Smart Meter, if
12
applicable.
Write data in scratch pad
13
memory, if desired.
Store all changes in the
14
transmitter's non-volatile
memory by pressing [
[ ].
ENTER
Reference Section
Appropriate vendor documentation
for controller or recorder used as a
receiver in analog loop with
ST 3000 transmitter.
5.2
6.3
5.3
5.4
6.4
6.5
6.7 (See 6.8 for local zero and
span adjustments)
7.3
7.4 - See Step 9 in Table 39.
7.8 - See Step 9 in Table 43.
8.2
6.11 or 6.12
8.4
6.13
] and
SHIFT
February 2012