Section 6 -Configuration; Introduction - Honeywell ST 3000 User Manual

6.1

Introduction

Section Contents
About this section
ATTENTION
February 2012 ST 3000 Release 300 and SFC Model STS103 User's Manual

Section 6 -Configuration

This section includes these topics:
Section Topic
6.1 Introduction ..................................................................................59
6.2 Overview ......................................................................................60
6.3 Entering a Tag Number ................................................................71
6.4 Selecting Output Form .................................................................73
6.5 Adjusting Damping Time ..............................................................76
6.6 Selecting Unit of Measurement ....................................................78
6.7 Setting Range Values Using SFC ................................................80
6.8 Setting Range Values Using Local Adjustments ..........................84
6.9 Selecting Output Signal Mode (DE Mode Only) ...........................91
6.10 Selecting Message Format (DE Mode Only).................................94
6.11 Configuring Smart Meter Using SFC............................................96
6.12 Configuring Smart Meter Using Pushbuttons .............................103
6.13 Disconnecting SFC ....................................................................122
This section introduces you to ST 3000 transmitter configuration. It
identifies the parameters that make up the transmitter's configuration
database and provides procedures for entering values/selections for the
given configuration parameters.
If you will be using the SCT 3000 software Release 3.12.2 or greater
instead of an SFC to configure the transmitter, follow the SCT 3000 on-
line help and on-line documentation to configure the transmitter's
database.
See Page
59