Advertisement
' ( )*
)*/ , . *, ( -' # ( '
)*( . )+ + ' .
Once you have completed the installation of System Controller you are ready to power up and configure
the System Controller for your application.
The Configurator is the software tool you use to setup and configure your system. The Configurator is a
point and click interface that you run from a computer during the installation, and later to make changes to
the system. Once the system has been set up, the Viewer interface described in Section 3 is used to
manage your system on a regular basis.
The Configurator communicates from your computer to the System Controller over an Ethernet network,
using either the included crossover cable or the included standard Ethernet cable.
The following section explains how to complete the network setup and configure the System Controller for
your network. Then, the Configurator is described in detail.
' + (
To use the Configurator you need a computer with a Java-enabled web browser. In addition, your
computer and the System Controller need related IP addresses so they can communicate over the
network.
To update your computer with the latest version of Java:
The System Controller interfaces rely on a web browser that is Java enabled. You can update your
computer to the latest version of Java over the Internet at no charge: start a web browser and go to
www.java.com. Click the Get it Now link, and then follow the instructions.
To check your computer's IP address:
The System Controller is sent from the factory with a default fixed IP address of 192.168.0.200. If your
computer has an IP address that begins with 192.168.0 then proceed to the next section: The
Configurator on page 12. If you don't know the IP address of your computer, then proceed as follows:
On Windows computers:
1. Click Start, Run to bring up the Run dialog similar to that shown below:
"
Advertisement
