Advertisement
To change the passwords for the interfaces:
The System Controller supports two users: User and Admin.
User has access to the Viewer interface on a regular basis for making changes to setpoints, turning
heating on or off, etc.
Admin also has access to the Configurator for making changes to the setup of the system.
In normal installations it is common to have a password for Admin and no password for User. This
prevents accidental changes to the system setup, while allowing day-to-day users easy access to the
system.
1. Click the System tab, then click the desired user under Contacts and Users in the tree structure as
shown below:
2. Click Set Password to bring up the password dialog shown below:
3. Type in the new password in both boxes and click OK. Note that the System Controller is shipped
with no password set for either User or Admin.
IMPORTANT NOTE: If you would like a password for User, be sure to first setup a password for Admin.
IMPORTANT NOTE: If you would like to remove a password for User, click Set Password and leave
both fields blank, and then click OK. You will no longer be prompted for a password for that user.
Advertisement
