Advertisement
There are four steps to setting up the System Controller with the Configurator, which are explained in the
following sections:
1. Set basic system-wide settings, such as system time and service override.
2. Add and configure thermostats, including setting the thermostat name and energy management
settings.
3. Add and configure the heating and cooling equipment.
4. Add and perform initial configuration of schedules which set, for example, the number of master
schedules (up to 4) and the number of periods per day. The actual setting of the temperature and
the start times is done with the Viewer as explained in Section 3.
To start the Configurator:
The Configurator is an easy to use interface that is accessed through a web browser.
1. Start a web browser on your computer.
2. Place the cursor in the address field and type http://192.168.0.200. If you changed the IP
address of the System Controller during the preceding steps, then enter that address instead of
192.168.0.200.
3. Press Enter: the System Controller welcome page is displayed.
To add a shortcut for the Configurator on your desktop:
To access the interface more quickly you can create a desktop shortcut that brings up the System
Controller welcome page with the following steps.
1. Click Create a Desktop Shortcut Now.
2. The File Download dialog appears as shown below: click Save. In the Save As dialog that appears,
click Desktop as shown below, then click Save.
Advertisement
