Using The Ftp Command From The Command Line; Example Of Ftp Commands From The Command Line; Figure 206 Telnet In Menu 24.5 - ZyXEL Communications Prestige 660H Series User Manual

Figure 206 Telnet in Menu 24.5

To transfer the configuration file to your workstation, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and SMT
password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current Prestige configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Prestige manual.

35.2.2 Using the FTP Command from the Command Line

1 Launch the FTP client on your computer.
2 Enter "
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "
6 Use "
get
config.rom
renames it "
conventions.
7 Enter "

35.2.3 Example of FTP Commands from the Command Line

Chapter 35 Firmware and Configuration File Maintenance
Menu 24.5 - System Maintenance - Backup Configuration
Press ENTER to Exit:
", followed by a space and the IP address of your Prestige.
open
" to set transfer mode to binary.
bin
" to transfer files from the Prestige to the computer, for example, "
" transfers the configuration file on the Prestige to your computer and
". See earlier in this chapter for more information on filename
config.rom
" to exit the ftp prompt.
quit
Prestige 660H/HW Series User's Guide
get rom-0
320