Gateway E-420 Maintaining & Troubleshooting page 41

Caution!
Never try to remove a
DIMM without releasing the
clamps. You may break the
socket, causing serious
damage.
30 Maintaining and Troubleshooting Your E-4200 System
Pull open the socket clamps on each side of the DIMM socket.
3.
Insert the DIMM into the socket and align the two notches in the
4.
DIMM with the two notches in the DIMM socket.
Gently press the DIMM into the socket until it doesn't move any
5.
farther. (Inserting the DIMM automatically locks each of the socket
clamps on each end of the DIMM.)
Close the case, as described in Chapter 1.
6.
Reconnect the power cord and turn on the system.
7.
Gently push out the plastic socket clamps on each end of the DIMM.
1.
The DIMM should pop up slightly from the socket.
To remove DIMMs