Gateway E-420 Maintaining & Troubleshooting page 38

Push in the tabs on the outside edges of the bottom bracket and pull
B.
the bracket away from the processor.
Press in the two latches at the top of the processor, and pull the
C.
processor up and out.
Push the new processor into the slot until it snaps into place.
D.
Push the support bracket back into the base of the processor until it
E.
snaps into place.
Replace any DIMMs you removed.
F.
Replace the stability bar and fan duct if applicable.
8.
Close the case, as described in Chapter 1.
9.
Plug in the power cord and turn on the computer and monitor.
10.
Check to see if your system has automatically detected the processor
11.
speed.
When you see the Gateway logo on the screen, press T
A.
the system messages.
Check the processor speed displayed on the screen. If the correct
B.
speed is shown, your system has automatically detected the
processor speed.
If an incorrect speed is shown, you need to open a special menu in
your system's Setup program to manually set the correct processor
speed. Setting system board jumper J7B1 opens this menu.
Bottom bracket
to display
AB
System Components 27