Page 30 – Ringer Controls
Setting a Ringer Step
Setting the Ringer Timeout
Automatic External Call Connection
INDeX 9.1 2030/50/60
If a call rings unanswered, the phone can increase the volume on
each ring until it reaches its maximum. You can select several sizes
of increase step.
To set the ringer volume step size:
1. Press PROGRAM and then RINGER.
2. Enter the phone's passcode (see page 33).
3. Press STEPS. The display shows the current setting; LARGE
STEP, SMALL STEP or NO STEP (no increase).
4. To select another step size, press CHANGE.
5. Press PROGRAM to finish.
The ringer timeout control several actions.
• Callback:
How long a callback rings you before cancelling.
• Group hunting:
How long calls to a group of which your phone is a member, ring
your phone before trying the next member.
• Divert on no answer:
How long calls ring at your phone before the system uses Divert
on No Answer if set.
To set the ringer timeout:
1. Press PROGRAM and then RINGER.
2. Enter the phone's passcode (see page 33).
3. Press TIMEOUT. The display shows the current setting.
4. Press CANCEL and enter the new timeout in seconds. The
normal value of 10 seconds is equal to 3 rings.
5. Press PROGRAM to finish.
The System Manager can set 2050/2060 phones with ACD operation
into free flow mode. In this mode, the system connects external calls
automatically after just a single tone (but not transferred external
calls). After you end the call, the system waits 3 seconds before
connecting any following call.
38DHB0002UKCL - Issue 5 (12/00)