Explanation Of Menu Items; Printer Control; Symbol Sets - Oki Microline 3390 User Manual

Explanation of menu items

Emulation Mode: You use this item to define the command set. The
emulations available to you are Epson LQ, IBM ProPrinter and
IBM AGM. The Alternative Graphics Mode (AGM) includes partial
compatibility with the Epson LQ series which is largely limited to
graphics and line feed commands. The commands available in
AGM are indicated in the appropriate chapters.
Print Mode: You can select here the required font for the document.
Pitch: You set here the character width in characters per inch (cpi).
Proportional Spacing: The fonts in letter quality can optionally be
printed with proportional spacing.
Style: You select normal or italic characters.
Size: You can switch between single font size and combination of
expanded horizontal and vertical font.
Character Set: You can select here between IBM character sets Set I
and Set II. In Epson emulation, Set II corresponds to an extension of
the printable characters.
Language Set: When you select a national character set, this replac-
es some characters with the special characters of the respective lan-
guage.
Zero Character: Select Slashed if you wish zero to have a slash
through it in order to better differentiate it from capital O.
Code Page: A code page is a character set that contains country
specific characters. In IBM emulation it can be used as character set
I and II or as a fully printable character set. In Epson emulation, all
characters can be made available via the "Extension of printable
characters". In addition, certain characters in the lower range can be
replaced by choosing a national character set (Language Set).
Slashed Letter O: The characters ¢ (155) and ¥ (157) are replaced by
Ø and Ø when Yes is selected.
Chapter 4: Printer menu settings

Printer Control

Font

Symbol Sets

A table of all the character
sets and code pages is to be
found in Chapters 10, 14 and
Appendix B.
4-9