Explanation Of Menu Items - Oki Microline Ml184T+ Handbook

Explanation of Menu Items

These explanations are in alphabetical sequence to make it easier to look
them up. Many of the items will appear only with optional equipment installed,
as noted below. You will find the items Line Spacing, and Page Length
appearing several times in the menu (once for each paper path).
7 or 8 Bit Graphics. Choose 7 (factory default) or 8 bits.
7 or 8 Bit Data word. Choose 8 (factory default) or 7 bits.
Auto CR. IBM mode only. No or Yes (factory default) . Choose Yes to
make your printer automatically perform a carriage return when a LF is
received at the end of the line.
Auto LF. No (factory default) or Yes. Change to Yes if your printer overprints.
Keep this set to No if your software adds a line feed when a carriage is
received at the end of a line. If your printout is consistently double spaced,
set this item to No.
Auto Select. No (factory default) or Yes. Determines whether or not your
printer will automatically be selected after you load in paper. With the
factory default (No) engaged, the printer will be deselected so that you can
set the Top of Form. If you always use the same Top of Form setting,
change this setting to Yes so that you don't have to press the SEL button to
select the printer after loading paper.
Auto Feed XT. Epson mode only. Invalid (factory default) or Valid. In the
Epson emulation, the XT signal on pin 14 of the parallel interface can
control automatic line feed. Some interface cables are wired in such a way
that automatic line feed is always in effect: the Auto Feed XT item eliminates
this potential problem. The factory setting causes the printer to ignore this
signal; if your system uses pin 14 to control automatic line feed, change
the setting to Valid.
D -- 6 Appendix D: Menu Selections