Oki Microline 3390 User Manual page 110

2. Remove the panel on the
right, rear side of the printer
by breaking it out with a
slot-head screwdriver or by
cutting it out with a knife.
3. Take the card out of its pack-
ing and slide the card along
the guide slot as far as the
stop inside the case until you
can feel it make contact. It
will automatically engage
there.
4. Plug the printer end of the
interface cable into the sock-
et on the back of the printer.
Secure the cable with the
two screws.
Chapter 7: Accessories
A clip may be enclosed which
is not required for this model.
7-29