Oki Microline 3390 User Manual page 139

The parameters p
1
commands ESC 3 (variable line spacing) and ESC J (variable line
feed).
p = integer value (n /256)
2
p = n - (p * 256)
1 2
When the printer is turned on the basis for line spacing for ESC 3
and ESC J is set to 1/216 inch, in AGM mode to 1/180 inch.
The following table shows the permissible values for the parameters
m , m and p , p . Values that are not listed in the table will be
1 2 1 2
ignored.
m , p
1 1
00
48
72
96
120
144
180
216
240
160
Function
Form feed
If a form feed (FF) command is sent, the printer prints all data in the
line buffer and sets the current print position at the start of the next
page. You can also advance a page to the start of the next page by
pressing the FF key on the control panel.
and p define the basis for line spacing for the
2
m , p Function
2 2
00 no change
00 Basis of 1/48 inch
00 Basis of 1/72 inch
00 Basis of 1/96 inch
00 Basis of 1/120 inch
00 Basis of 1/144 inch
00 Basis of 1/180 inch
00 Basis of 1/216 inch
00 Basis of 1/240 inch
05 Basis of 1/1440 inch
Dec. Hex.
12 0C
Chapter 10: IBM - Standard Functions
Form feed
ASCII
FF
10-19