Oki Microline 3390 User Manual page 276

5. Printing starts when the printer has received the entire com-
mand.
If P = 0, the bar code cannot be printed.
1
6. The following values are valid for P
garded as one character:
(a) EAN8
(b) EAN13
(c) UPC-A
(d) UPC-E
(e) Code 39
(f) Interleaved 2/5
(g) Code 128 (Set A, B, C)
If the Code 128 is selected, P
The value for P cannot be changed for bar code types listed under
1
(a) to (d).
For the bar code types listed under (e) through to (f) you can select
any value listed under number 6.
If P is larger than the above-mentioned numbers, the command
1
will be ignored.
7. The following characters are valid data for printing:
(a) EAN8
(b) EAN13
(c) UPC-A
(d) UPC-E
(e) Code 39
43 characters, see Table 5
(f) Interleaved 2/5
(g) Code 128 (Set A)
(h) Code 128 (Set B)
(i) Code 128 (Set C)
for characters of Code 128, see Table 6
Only the above mentioned data and checksum code is valid.
8. A checksum is generated automatically by sending a checksum
code at the end of the bar code data.
. The check digit code is re-
1
8 characters
13 characters
12 characters
6 characters
maximum of 50 characters
maximum of 50 characters
maximum of 50 characters
is regarded as one character.
m
0 (30H) to 9 (39H)
0 (30H) to 9 (39H)
0 (30H) to 9 (39H)
0 (30H) to 9 (39H)
SP (20H) to Z (5AH)
0 (30H) to 9 (39H)
(00H) to (66H)
(19H) to (7FH)
(30H) to (3CH)
Appendix C: Bar codes
C-9