Oki Microline 3390 User Manual page 105

Chapter 7: Accessories
Changing between
different formats of
continuous paper
7-24
You can set the values for paper handling as you wish by means of
the printer menu in the Bottom Feed group.
If you are feeding continuous paper from the rear and wish to use
continuous paper from the bottom tractor feed, proceed as follows:
1. Part the printed pages along the perforation.
2. In ON LINE mode, press the PARK button. The continuous pa-
per is transported backwards but remains held in the bottom
tractor feed.
3. Move the paper release lever on the right side of the printer to-
wards the back; the symbol for continuous paper handling from
below shows the correct setting for the lever.
4. Press the FF/LOAD button. The continuous paper held in the
bottom tractor feed is fed in. Redefine the top of form if neces-
sary.
If the print job is finished and you wish to use the continuous paper
from the bottom tractor feed, proceed as follows:
5. Part the printed pages along the perforation. Press the PARK
button. The continuous paper is transported backwards but
remains held in the bottom tractor feed.
6. Pull the paper release lever on the right side of the printer to-
wards the front; the symbol for continuous paper handling from
the rear shows the correct setting for the lever.
7. Press the FF/LOAD button. The continuous paper is again fed to
the platen from the rear of the printer.