Installing The Rear Brake Master Cylinder - Yamaha YFM7FGPW Service Manual

1
2
b
60˚
FRONT AND REAR BRAKES
EBS00418
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• brake master cylinder 1
• brake master cylinder holder 2
a
NOTE:
_
• Align the end of the brake master cylinder
• The "UP" mark b on the brake master cylin-
2. Install:
• brake hose
• copper washers
• union bolt
NOTE:
_
• Tighten the union bolt while holding the
• Turn the handlebar to the left and to the right
_
Proper brake hose routing is essential to
insure safe vehicle operation. Refer to
"CABLE ROUTING" in chapter 2.
8 - 21
7 Nm (0.7 m · kg, 5.1 ft · lb)
holder with the punch mark a on the handle-
bar.
der holder should face up.
New
27 Nm (2.7 m · kg, 19 ft · lb)
brake hose as shown.
to check that the brake hose does not touch
other parts (throttle cable, wire harness,
leads, etc.). Correct if necessary.
WARNING
CHAS