Roland M-200i V-mixer Owner's Manual page 41

CHANNEL EDIT screen
Attenuator
1
ATT knob
1
This adjusts the input level of the channel in a range of -48.0
dB to 0.0 dB.
Overload indicator
2
This will light when the output of the attenuator exceeds the
OVER LEVEL setting specified in the METER FUNCTION screen
(p. 59).
Normally, you should leave the attenuator set at 0 dB.
When the input of an AUX, MTX, or MAIN is overloaded,
however, you can use the attenuator to avoid overload.
Balance
2
This adjusts the left/right output balance for MAIN L/R or for
stereo-linked AUX/MTX buses in a range of L63 to R63.
DELAY
3
DELAY button
1
This turns delay on/off.
Delay time
2
This adjusts the amount of delay in a range of 0.0 ms to 400.0
ms.
4 COMP/LIMITER button
This turns the compressor or limiter on/off.
For information on editing compressor or limiter parameters,
refer to "COMPRESSOR/LIMITER screen" (p. 49).
The compressor and limiter cannot be used concurrently.
AUX, MTX, MAIN operations
5 EQ
EQ graph
1
This shows the approximate response of the EQ.
EQ button
2
This turns the 4-band EQ on/off.
For information on editing 4-band EQ parameters, refer to "4-
band EQ operations" (p. 55).
TO MAIN (AUX only)
6
PAN
1
This adjusts the panning of the audio signal sent to MAIN L/R
in a range of L63 to R63.
MAIN button
2
This turns the send to MAIN L/R on/off.
7 Faders
This adjusts the output level in a range of -Inf dB to +10.0 dB.
41