Roland M-200i V-mixer Owner's Manual page 45

GATE/EXPANDER screen
1.
In the fader module section, press [SEL] to select the
desired channel.
2.
In the CHANNEL EDIT section, press [GATE].
The GATE/EXPANDER screen appears. (The name of the
screen varies depending on the type of gate selected.)
ON button
1
This turns the GATE/EXPANDER on/off.
2 IN meter
This shows the input level of the gate/expander. This shows
the level of the key-in signal when the KEY-IN FILTER is on or
the KEY-IN SOURCE is not SELF. For stereo-linked channels,
two meters (L and R) are shown.
GR meter
3
This shows the amount of gain reduction for the gate/
expander.
OUT meter
4
This shows the output level of the gate/expander. For stereo-
linked channels, two meters (L and R) are shown.
Parameter
5
This sets the parameters for the gate/expander.
The parameters differ according to type.
GATE/EXPANDER screen
Gate
fig.PopGateGuide2.eps
THRESH knob
1
This adjusts the threshold level in a range of -80.0 dB–0.0 dB.
RANGE knob
2
This adjusts the RANGE in a range of -Inf dB–0.0 dB.
ATTACK knob
3
This adjusts the ATTACK time in a range of 0.0 ms–800.0 ms.
This is the time from when the input signal exceeds the
threshold level until the gate opens completely.
RELEASE knob
4
This adjusts the RELEASE time in a range of 0 ms–8000 ms.
This is the time over which the gate reaches its maximum
effect after the HOLD time has elapsed.
HOLD knob
5
This adjusts the HOLD time in a range of 0 ms–8000 ms. This
is the time from when the input signal falls below the
threshold level until the gate begins closing.
45