Roland M-200i V-mixer Owner's Manual page 128

Appendix
REVERB+GATE
fig.AlgoRevwGate.eps
DRY
Input L
4 Band EQ
Reverb
Input R
DRY
This is a mono-in, stereo-out reverb. It provides a gate that can be
used for gating or ducking, allowing you to cut the reverb during
its decay, or to cut the reverb when the level of the original sound
is high.
Reverb
SIZE (Room size)
Size of the room or hall
Value: 5–40 m
TIME (Reverb time)
Length of the reverberation
Value: 0.1–32.0 s
Pre Dly (Pre-delay time)
Time until the early reflections is heard
Value: 0–200 ms
ER Lev (Early reflection level)
Level of the early reflections
Value: -INF–0.0 dB
DIFFUS (Diffusion)
Amount of scattering for the early reflections
Value: 0–100
DENSITY
Density of the reverb sound
Value: 0–100
LO FREQ DAMP GAIN
Low-frequency attenuation of the reverb sound
Value: -36.0–0.0 dB
LO FREQ DAMP FREQ
Frequency at which the low-frequency region of the reverb
sound begins to be attenuated
Value: 20 Hz–2.00 kHz
HI FREQ DAMP GAIN
High-frequency attenuation of the reverb sound
Value: -36.0–0.0 dB
HI FREQ DAMP FREQ
Frequency at which the high-frequency region of the reverb
sound begins to be attenuated
Value: 200 Hz–20.00 kHz
128
HI CUT FREQ
Output L
WET (Wet Level)
Gate
Key-In
Output R
DRY (Dry Level)
EQ
EQ SW (EQ switch)
EQ ATT (EQ attenuator)
LO GAIN
LO FREQ
LO-MID TYPE
LO-MID GAIN
LO-MID FREQ
LO-MID Q
HI-MID TYPE
HI-MID GAIN
Frequency at which the high-frequency region of the reverb
sound will be cut
Value: 200 Hz–20.00 kHz
Level of the reverb sound
Value: -INF–+6.0 dB
Level of the original sound
Value: -INF–+6.0 dB
Turns the EQ on/off
Value: OFF, ON
Attenuator for the EQ
Value: -42.0–+6.0 dB
Gain of the Lo band
Value: -15.0–+15.0 dB
Center frequency of the Lo band
Value: 20 Hz–20.00 kHz
Filter type for the Lo-Mid band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2,
BPF, BEF, THRU
Gain of the Lo-Mid band (*1)
Value: -15.0–+15.0 dB
Center frequency of the Lo-Mid band (*1)
Value: 20 Hz–20.00 kHz
Steepness of the frequency response curve at the Lo-Mid band
center frequency (*1)
Value: 0.36–16.00
Filter type for the Hi-Mid band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2,
BPF, BEF, THRU
Gain of the Hi-Mid band (*1)
Value: -15.0–+15.0 dB