Roland M-200i V-mixer Owner's Manual page 122

Appendix
Output Impedance
ASSIGNABLE OUTPUT jacks (1 to 10): 600 ohms (typ.)
MAIN OUTPUT jacks (L, R): 600 ohms (typ.)
PHONES jack: 49 ohms (typ.)
Recommended Load Impedance
ASSIGNABLE OUTPUT jacks (1 to 10): 10 k ohms or greater
MAIN OUTPUT jacks (L, R): 10 k ohms or greater
PHONES jack: 40 ohms or greater
Minimum Load Impedance
PHONES jack: 16 ohms
Non Clip Maximum Output level
ASSIGNABLE OUTPUT jacks (1 to 10): +22 dBu (1 kHz, 10 k ohms load, typ.)
MAIN OUTPUT jacks (1 to 10): +22 dBu (1 kHz, 10 k ohms load, typ.)
PHONES jack: 150 mW + 150 mW (1 kHz, 40 ohms load, typ.)
Residual Noise Level (IHF-A, typ.)
-88 dBu (All faders: Min)
-80 dBu (Main Fader: Unity, Channel faders: Unity only one INPUT1 channel, Preamp sens: Min)
-61 dBu (Main Fader: Unity, Channel faders: Unity only one INPUT1 channel, Preamp sens: Max)
* Input 150 ohms terminate
* Output Connector: ASSIGNABLE OUTPUT jacks (1 to 10), MAIN OUTPUT jacks (L, R)
* Sample Rate: 48.0 kHz or 44.1 kHz
Equivalent Input Noise Level (E.I.N.)
-126 dBu (Main Fader: Unity, Channel faders: Unity only one channel, Preamp sens: Max)
* Output Connector: ASSIGNABLE OUTPUT jacks (1 to 10), MAIN OUTPUT jacks (L, R)
* Sample Rate: 48.0 kHz or 44.1 kHz
Audio Signal Latency
2.0 mS (typ.)
* Total System Latency of audio signal from an INPUT jack to a MAIN OUTPUT jack.
* Sample Rate: 48.0 kHz
* Effects: No insert effects
Network Latency
2.5 mS (typ.) *1
* Total System Latency of audio signal from S-1608 inputs to outputs via M-200i's REAC ports.
* Sample Rate: 48.0 kHz
* Effects : No insert effects
* 1: When a REAC Splitter S-4000D or a switching hub is used in-line with REAC cables, the network latency will increase by the amount of processing
delay introduced by the splitting device itself. The actual delay is dependant upon the specifications of the splitting device, though the maximum
delay amount for a single splitting device should be about 200 microseconds.
Connectors
INPUT jacks (1 to 16): XLR-3-31 type (balanced, phantom power)
INPUT jacks (17 to 22): 1/4 inch Phone type (balanced)
INPUT jacks (23 to 24): RCA Phono type
ASSIGNABLE OUTPUT jacks (1 to 6): XLR-3-32 type (balanced)
122