Datamax M-Class Operator's Manual page 85

Advanced Entry Calibration (continued)
Step Operator Action
16 Press the Key.
Using the or the
FWD
Key, set the 'Paper' level to the
value determined in the previous
step. Press the
the entry (indicated by the '*')
and advance the menu.
Repeat for the 'Gap' (or 'Mark')
and 'Empty' levels.
17 After all entries have been made,
press the Key to back out
of the menu and then press the
Key to save the settings
and return to the Ready Mode.
Note: If the Advanced Entry Calibration fails, try the following procedure.
Re-enter Media Settings / Calibration / Advanced Entry / Sensor Gain and lower the selected Gain Setting number by one
(to make the sensor less sensitive). Select the new Gain Setting, save the changes, exit the menu, and then test your
media. Repeat the procedure until a usable media setting is obtained.
M-Class
Displayed Message
!
QBQFS!TFOTPS!MFWFM!
Q+2:9!H+195!F+125!
REV
HBQ!TFOTPS!MFWFM!
Q+2:9!H+195!F+125!
Key to set
FNQUZ!TFOTPS!MFWFM!
Q+2:9!H+195!F+125!
Or, for reflective media:
QBQFS!TFOTPS!MFWFM!
Q+126!N+292!F+324!
NBSL!TFOTPS!MFWFM!
Q+126!N+292!F+324!
FNQUZ!TFOTPS!MFWFM!
Q+126!N+292!F+324!
TBWF!DIBOHFT@!
FOUFS!LFZ!>!ZFT!
!
!
The selection will flash and the display heading will
change to indicate the item for entry.
!
!
!
!
!
!
!
!
!
!
!
!
!
!
From 'Ready', press the FEED Key to advance to the
next label TOF.
!
Comment
77