Datamax M-Class Operator's Manual page 78

Standard Calibration (continued)
Step Operator Action
7 Proceed according to your media
type:
Die-cut stock: strip the media
from the backing and then
reinsert it into the sensor; adjust
the Sensor Eye Mark over the
center of the backing.
Notched stock: adjust the
Sensor Eye Mark over the center
of the notch.
Reflective stock: Adjust the
Sensor Eye Mark over the center
of the facedown black mark.
Continuous stock: go to Step 8.
Press the key to continue.
Note: Do NOT move the position of the Media Sensor after it has been adjusted.
8 Position the label (and backing,
if any) under the Sensor Eye
Mark.
Note: If using preprinted
media, ensure the label area
under the sensor is free of
preprinted text, graphics or
borders.
Press the key to continue.
70
Displayed Message
TDBO!CBDLJOH!
QSFTT!FTD!LFZ!!!=zzz?!
!
Or, for reflective media:
!
TDBO!NBSL!
QSFTT!FTD!LFZ!!!=zzz?!
!
TDBO!QBQFS!
QSFTT!FTD!LFZ!!=zzz?!
!
!
Comment
This sets the parameter for the 'gap' or 'mark' value.
Where 'yyy' is a numerical value representing the
current sensor reading: useful in locating the best
sensor position.
Note: Never position the sensor over a perforation
when recording a sensor reading.
This sets the parameter for the 'paper' value.
Where 'yyy' is a numerical value representing the
current sensor reading.
M-Class