Table of Contents
Advertisement
Advanced Entry Calibration (continued)
Step
Operator Action
6
Press the
Key to scroll to
FWD
'Advanced Entry'.
7
Press the
Key.
8
Press the
Key.
FWD
9
Press the
Key.
Place the label under the Sensor
Eye Mark and lower the
printhead assembly.
10 Press the
Key to select
the setting (denoted by an '*')
and then record the sensor
reading (the 'yyy' value) in a
table similar to the one shown
after Step 12, as a Label Value.
Next, press the
FWD
increment the Gain Number.
Repeat this step for each of the
Gain Numbers (00-32).
M-Class
Displayed Message
!
TFOTPS!DBMJCSBUJPO!
BEWBODFE!FOUSZ!
!
!
BEWBODFE!FOUSZ!
TFOTPS!MFWFMT!
!!
!
BEWBODFE!FOUSZ!
TFOTPS!HBJO!
!!
!
HBJO!USBO!!!!!=zzz?!
+11!!!!!!!!=1!.!42?!
!
-OR-
HBJO!SFGM!!!!!=zzz?!
+11!!!!!!!!)1!.!42*!
!
HBJO!USBO!!!!!=zzz?!
+11!!!!!!!!=1!.!42?!
!
-OR-
HBJO!SFGM!!!!!=zzz?!
+11!!!!!!!!)1!.!42*!
Key to
Comment
You are entering Advanced Entry Calibration.
Press the
Key to abort this procedure.
You are beginning the Advanced Entry Calibration.
If using preprinted media, ensure the label area under
the sensor is free of preprinted text, graphics or
borders.
Where 'yyy' is a numerical value representing the
current sensor reading: useful in locating the best
sensor position.
Note: Never position the sensor over a perforation
when recording a sensor reading.
73
Advertisement
Table of Contents
