Skoda Rapid Owner's Manual page 26

24 Instrument cluster
Possible indications
Menu
Driving time
Current fuel consumption
Average fuel consumption
Range
Distance travelled
Average speed
Warning at --- mph
Outside temperature
Operating the menus in the instrument cluster
ä
First read and observe the introductory information and safety warn-
ings on page 23.
Selecting memory 1 or 2
● Switch on the ignition.
● Press the button repeatedly
OK/RESET
memory.
Function
Driving time in hours (h) and minutes (min) that has elapsed after the ignition has been switched on.
The current fuel consumption is indicated while driving in mpg (l/100 km) or with the engine running and the vehicle
stopped in gallons per hour (litres per hour).
The average fuel consumption in mpg (l/100 km) will appear after the ignition is switched on only after a distance of
about 328 feet (100 metres). Until then, dashes are displayed. The displayed value is updated approx. every five sec-
onds.
Approximate driving distance in miles (km) that can be driven with the existing fuel amount in the tank using the same
driving style. This is calculated based on the current fuel consumption among other factors.
The distance travelled in miles (km) after the ignition has been switched on.
The average speed is displayed after the ignition has been switched on only after a distance of about 328 feet (100
metres). Until then, dashes are displayed. The displayed value is updated approx. every five seconds.
When exceeding a stored speed from approx. 18 mph (30 km/h), an acoustic and possibly a visual warning are issued.
Display of the current outdoor temperature in °F or °C.
Fig. 10 Button A on the
windscreen wiper lever to con-
firm a menu item, and rock-
er to change the menus.
B
⇒ f ig. 10
until you see the desired
A
Manually clearing memory 1 or 2
● Switch on the ignition.
● Select the memory you wish to clear.
● Press and hold the button for approx. two seconds
OK/RESET
Display of driving and fuel consumption data
● Switch on the ignition.
● Select memory.
● Push the rocker up or down repeatedly
Storing a speed for the speed warning
● Select speed warning.
● Press the button A to save the current speed and activate the
OK/RESET
warning.
● If necessary, within approx. five seconds set the desired speed with the rocker
B . Then press again the button or wait a few seconds. The speed is
OK/RESET
saved and the alarm is activated.
● To deactivate, press the button. The stored speed is deleted.
OK/RESET
.
A
B until the desired value is displayed.
Ð
£