Table of Contents
Advertisement
FCC Part 68 Statement
Canadian CS-03
Approval Information
S
UPPLEMENTARY
I
NFORMATION
This section describes the compliance of the SuperStack
the SuperStack II PathBuilder S310 WAN access switches (PathBuilder S330/S310
switches) with FCC, Industry Canada, and CE regulations.
This equipment complies with Part 68 of the Federal Communications
Commission (FCC) rules. On the product is a label that contains the FCC
registration number for this device. If requested, you must provide this information
to the telephone company.
This equipment is designed to be connected to the telephone network or premises
wiring using a compatible modular jack which is Part 68 compliant. See
installation instructions for details.
If this device causes harm to the telephone network, the telephone company will
notify you in advance that temporary discontinuance of service may be required.
The telephone company may request that you disconnect the equipment until the
problem is resolved. The telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the operation of this
equipment. If this happens, the telephone company will provide advance notice in
order for you to make necessary modifications to maintain uninterrupted service.
If you experience trouble with this equipment or for repair or warranty
information, please follow the applicable procedures explained in the Technical
Support section of this manual (Appendix A).
The Industry Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective,
operational, and safety requirements. Industry Canada does not guarantee the
equipment will operate to your satisfaction.
Before installing this equipment, you should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. You must
also install the equipment using an acceptable method of connection. In some
cases, the inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly. You should be aware that
compliance with the above conditions may not prevent degradation of service in
some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations you
make to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request that you disconnect the
equipment.
FCC Part 68 Statement
R
EGULATORY
®
II PathBuilder
xiii
™
S330 and
Advertisement
Table of Contents
